SANWA SUPPLY Four horizontal articulated LCD monitor arms　CR-LA1505BK

Feature

• Can be equipped with 4-sided monitor.
• Horizontal Articulated Monitor Arm
• Can be moved freely in all directions relative to horizontal space.
• You can choose between clamp type (compatible with 10 mm to 50 mm plate thickness) and grommet type for installation.
• Slim clamps make it less susceptible to cushioning of the back panel of the desk.
• Compatible with VESA standard installation. (75 x 75 mm, 100 x 100 mm) * * In the case of 75 mm, if there is a dent in the mounting position, it cannot be mounted.
• The hardness of each joint can be adjusted with an attached tool.
• The cable from the LCD can be passed through the cable holder on the lower surface of the arm.
• The tilt angle of the display mounting section is 85° and 60°, respectively.
• The length of the pole is 710 mm (from the desk surface to the pole tip), and the thickness of the pole is φ32 mm.
• Total load capacity is 8 kg.

Specifications

• Size: See Dimensions Diagram
• Packing: 1 inlet
• Ship Type: Knockdown Assembly
• material : Steel (strut Department) , Aluminum (Clamp part and arm part) , ABS (Bracket)
• Accessory: Adjustment Tool, Display Mounting Screw (M4 x 12)
• Range of motion: screen rotation (rotation)/90 ° left and right (Swing)/360 ° screen left and right (bread)/180 ° screen upper and lower (Tilt)/145 °
• Total Load tolerance: 8kg (per arm)
• *Do not install a display that exceeds Load tolerance specifications. ・total with the arm on which the liquid crystal display is mounted
• Weight may weigh more than 8 kg. When assembling or working with the arm, be sure to use two or more people.
• The retention force of each arm and tilt joint at the factory differs depending on the product. After installing the arm, be sure to adjust the nut and bolt incorporated in the joint to obtain the optimum holding force.
• Operate the arm gently (Angle adjustment, etc.). Also, be sure to operate with both hands. Rough or repeated operation may damage the joint between the LCD and the arm or the base of the arm.
• If force is applied to the tip of the strut when fixing the screws, the desktop surface may be damaged. Therefore, take care not to apply force to the strength of the installation site.
• Do not place the LCD on the edge of the table or operate it in the direction of the edge of the table. If a downward force is applied to the LCD while it is overhanging, it may fall off the table.
• Do not install the product in areas subject to strong vibration or areas subject to continuous vibration for a long period of time.
• The assumed design operating environment temperature is 0 to 40 ° C. Do not use in an environment outside that range.

Package size

• Package size：855×395×160 mm 9 kg