Cytiva (Whatman) Polyvent 75 (PTFE 0.2 微米) 6713-1075

Features

• Passed sterilization grade HIMA challenge test
• The catch count of Brevundimonas diminuta was more than 10^7 CFU/cm2, which complies with ASTM standard F838-83.
• This ability to retain microorganisms correlates with the 100%%%% integrity test (evaluated in liquid form) in the manufacturing process (100%%%% integrity test is only performed in capsule form).
• An integrated filter developed for sterile venting. Consisting of only one standardised material (PTFE membrane and polypropylene housing) helps simplify the approval process.
• Hydrophobic PTFE membrane with a pore size of 0.2 μm
• Steam sterilization by autoclave is possible up to 50 times, and ethylene oxide gas is also supported.
• Water breakthrough (WBT) test or bubble point test possible
• Manufactured in a clean room facility
• Both Directions Enabled
• Note)Only for test and research purposes.

Specification

• Housing: Polypropylene
• Filter Material: PTFE (Polytetrafluoroethylene)
• Pore size: 0.2 μm
• vents: inlet side
• Support System: Polypropylene
• bonding methods: heat welding
• Voltage: 0.2 MPa (29psi) (if forward)
• Water Test: 0.2 MPa (29psi)/15 sec.
• Direction of filtration: reverse filtration is possible only at low pressure
• Sterilization: Autoclavable at 121°C for 20 minutes (maximum temperature 132°C). It is possible to autoclave repeatedly, but use at the user's responsibility to avoid cross contamination. Perform the integrity test after autoclaving. Sterilization with ethylene oxide gas is possible.
• No pyrogens: No response in the total LAL test
• Effective Filtration Area: 1,000 cm2
• Pore Diameter (μm): 0.2
• Type of housing: capsule type
• Connection Inlet: 1/2 "SB
• Connection Outlet: 1/2 "SB
• 1/2 "SB = Stepped Hose Port: Can be Connected to 10~12 mm (3/8" -1/2 ") Tubes

Package size

• 70x70x173mm
• 0.16kg